W hen the software loads, you will be prompt for a User ID and Password. Click on the setup tab in the upper left, then click on configuration.
Next, click on the Add button in the lower right and enter your DVR connection information. When you are done adding all of your DVRs to the configuration, click on the apply button in the lower right. The software will try to connect to all of your DVRs. You can check the device status field to confirm that it was successful. Press OK when done. The camera views that you create can be either private or shared.
Shared means that other users if you decide to create any can also have access. Select either private or public and click on the create new group button. Camera 'views' are organized into groups, which you can name whatever you want. After you create a group, select it and click on the create view button. You can choose either or video aspect ratio.
Then choose how many cameras you want to display and the type of layout to use. To add cameras to your view, you can expand each of your DVRs in the system overview window. Once 'DSSClient. Now launch the DSSClient installer 6. Select your language and press 'OK' 7. Select Next 8. There are many DVRs manufactured in China that do not have a brand and often do not even have manual or monitoring software, that's the reason why people start looking for alternative software for non-branded DVRs such as a universal CMS DVR software.
Let's start with a diagram that shows the installation of a DVR on the local network. In this case, it is necessary to configure it using internal IP. For other types of DVRs, the concept is the same. Make sure that your system is connected as shown in the diagram and check if the images are appearing on the local monitor before continuing.
Make sure that DVR is using the correct IP within your network, it doesn't matter if you are using another brand such as Dahua, Swann, etc. The IP configuration principle is the same.
Obviously, for your particular case, the IPs will be different from the example above, the important thing is that DVR and computer are configured in the same IP network range. I'm talking about DVR logic ports. Note that different brands of DVR can bring other nomenclatures, the important thing is to find the correct port for the application. The image below shows the DVR using port Other DVRs bring port by default.
Just check the menu to make sure what is the port. Just write down the ports your DVR is using, just in case you need the information later to configure remote viewing. Use a web browser to check if the local viewing is working fine. You can click on these icons and drag them to the center of the screen to view the images. At the center, the software shows all the cameras, at the bottom, there is a toolbar with log information such as date, channels, cameras, and users. On the left side menu, you can organize the devices in groups.
In this example, I separated everything by location and created the groups: 'Apartment', 'Dahua Office' and Optiview Office 'where each of the devices is located. ONVIF is a universal protocol for electronic security devices. In the right side menu, you can control PTZ cameras, adjust the picture with brightness, contrast, hue, and saturation, configure the system, use the playback menu and advanced settings.
Each of the buttons will open a menu that shows the options available for each case. The last button is used only to exit the system logout. In this menu located at the top right of the CMS H software you can check the date and time and to the percentage of CPU processing. When the system is recording, it is also possible to note the percentage of disk usage information.
In the local settings menu, you can configure the general settings for recordings, alarms, and DDNS. The center menu allows you to choose the image layout that will be displayed on the screen, with options for 1, 4, 8, 9, 13, 16, 25, 36, 64 cameras and full screen. When audio is enabled and configured on the device, you can open the channel to play it. Just click the icon to increase the volume. The bottom part of the menu shows the date, equipment, channels, connected users and the status of each device.
Whenever you need to include, delete, and change new zones zones and devices, simply click on the device manager icon on the right side menu.
0コメント